Tinker Mission · 01
Project recap sheet
Intrusion alarm
A page to fill in after the build. Print it and keep it with your notes.
Built on
Built by
What I built
What I learned
Sensors · Pull-up resistors · If/then code · Deep sleep · Battery power
What went wrong, and what I changed
Next time, I want to try
Parts used
- 1 × ESP32 board
- 1 pair × Infrared break-beam pair, 5 mm
- 1 × 4×AA battery holder with ON/OFF switch, cover and header-pin ends
- 1 × 3×AA battery holder with ON/OFF switch and cover
- 7 × AA batteries
- 2 × WAGO 221-412 lever connectors
- 1 × 220 Ω resistor
- 1 × LED
- 1 × Active buzzer module
- 1 × Push button
- 1 × Breadboard
- 1 set × Jumper wires
- 1 × USB data cable