Safety rules
The rules that apply to every project on Tinker Mission. Read them once, then keep them near the workbench.
Always
- Ask for help when a step says so. Steps marked “Ask for help” are done with an adult or an experienced helper next to you.
- Unplug before you rewire. Changing wires while powered is how parts (and fingers) get hurt.
- Red is +, black is −. Check twice before connecting a battery.
- Motors and servos get their own power, never the board’s pins. Connect all the GND wires together.
Never
- No mains voltage. Nothing on this site is plugged into a wall socket except ready-made, certified adapters.
- No bare LiPo cells. We use AA batteries, USB power banks and plug-in adapters only.
- No laser above Class 2, no laser at eye level, no mirrors.
- No glitter, no projectiles at people or animals. Targets are objects.
Soldering and hot glue
Soldering and hot glue are “Ask for help” steps: do them with an experienced helper next to you. The iron always goes back in its stand. Wash hands after soldering.
Cameras
A camera project films only people who said yes, never in bathrooms or other people’s bedrooms, never over a fence.
Report a problem
If a sheet looks unsafe or wrong, stop, unplug, and ask an adult before going on.
Your responsibility
These sheets are shared for learning, free and as is. We check every step, but we cannot see your bench, your parts or your tools. You build at your own risk; children build with an adult who has read the sheet. If something heats up, smells or smokes: unplug and remove the batteries first.
3D printing
The nozzle and bed get very hot: do not touch them while printing or right after. Print in a ventilated room and keep small children and pets away from the printer.