Tinker Mission · 08
Project recap sheet
Morse spy beacon
A page to fill in after the build. Print it and keep it with your notes.
Built on
Built by
What I built
What I learned
Timing with millis · Reading a button (debounce) · Lookup tables · Decoding signals · Deep sleep · Battery power
What went wrong, and what I changed
Next time, I want to try
Parts used
- 1 × ESP32 board
- 1 × Breadboard
- 1 × Yellow LED, 5 mm
- 1 × 220 Ω resistor
- 1 × Active buzzer module
- 1 × Push button
- about 10 × Jumper wires
- 1 × USB data cable
- 1 × 4×AA battery holder with ON/OFF switch, cover and header-pin ends
- 4 × AA batteries
- 1 set × Second complete base kit (board, breadboard, LED, 220 Ω, buzzer, button, wires, USB cable)
- 1 × Light-dependent resistor (LDR), GL5528 type
- 1 × 10 kΩ resistor
- 1 × Short opaque tube, 3–5 cm